Size or total program size does not match input. Invalid next message type value was detected in an Intermediate Or more PLC modules configured have unsupported revision. Invalid message type was received when an Intermediate Response Was made to read a device but no data has been stored on it.įraming or overrun error has occurred on an Intermediate Responseĭevice has insufficient memory to handle request.īCC (Block Check Code) error has occurred on an Intermediateĭevice is not available in the system (not present). Parity error has occurred on an Intermediate Response message. Stored on device has been corrupted and is no longer reliable.
Versapro software logic equal code#
Invalid response code was detected in an X-Response message.Ĭomm or write verify error occurred during save or restore.Įxpected X-Response message was not received within the response Invalid next message type value was detected in an X-Response Using nonzero buffer size required for block commands. Invalid message type was received when an X-Response message Program ( CP) tasks exist but requestor not logged into mainįraming or overrun error has occurred on an X-Response message.Īre set to inactive and cannot be enabled or disabled.īCC (Block Check Code) error has occurred on an X-ResponseĪlready enabled and cannot be forced inactive. Parity error has occurred on an X-Response message. Tasklevel Rack/Slot configuration to read or delete. Message twice without receiving a response. The response timeout interval when reestablishing an existing Message when re-establishing an existing SNP-X communicationĮxpected X-Attach Response message was not received within Invalid response code was detected in an X-Attach Response Response message when re-establishing an existing SNP-X communication Invalid Next Message Type value was detected in an X-Attach Communications have not been established. Was required when re-establishing an existing SNP-X communication
Invalid message type was received when an X-Attach Response The error could be related to any Address used in a C-more tag in the range of Q1 to Q16.
Therefore, an error for Address Q7 may be displayed as Q1 even though there is no tag associated with Q1 in the C-more panel. As a result, addresses reported with an error message show the beginning address of the block that the protocol attempted to read or write. Note: Addresses are read from or written to as 16 bit blocks by the protocol. To see the C-more Panel Errors Table, which provides Error Sure you are viewing the correct topic and locate the PLC Specific Errors Table 90-30 and Rx3i PLCs when using the SRTP Ethernet
0 kommentar(er)
